My LNR Precision MTR5b always comes away with me and for good reason. It’s small, portable and xyl friendly. It does however, suffer from a lot of wires and bits loosely hanging around. Mrs g7kse regularly takes the opportunity to ‘tidy’ stuff up. This means I can no longer find it. This is ok at home because it hasn’t gone far but a pain when I’m not at home.

Ikea has long been a source of cheap stuff and their chopping boards are just the thing to make into a small flight deck. The one I got is approximately 24cm by 15cm and came as a pack of two with a much larger one that is in use in the kitchen.

I thought the first thing to do would be make up a small tray that I can sit the MTR5b into and then still that to the board. Duly designed and 3d printed. Next up was a small notebook like the boys in blue use, after that some magnets for my palm key (it has a magnetic base). Lastly some velcro tape and 4 m4 nuts, bolts and washers. he optional part is a DC buck converter (just be careful to check dimensions as they change shape and size a bit) that I use to regulate the voltage to 12v (I got carried away and made a really bad case for it)

I thought I’d sink the magnets into the board at then epoxy them in. Mainly because its polypropylene and nothing sticks too well to these waxy plastics. All this took was a bit of careful dremelling and you’re done. The notebook is clipped to the board and the velcro strips stuck down onto the back. The ast ting to do was put 6 feet on it so I didn’t scratch any surface I carelessly chucked the thing on. Here’s a few photos and a link to the parts on Thingiverse.




Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.